Business Cards, Name tags(?), & Dovetails

     At our meeting last Wednesday, we had quite a good attendance with several new faces.  As is customary, we went around the room and introduced ourselves with a 15 second bio to make our new folks feel invited and jar the memory of some of the "old" folks who can't remember names!  The remark was made, somewhat tongue in cheek, that we should use name tags.  Mixed response to that but ........... another suggestion was offered that we could all make our own name tags out of wood to wear at the meetings.  What do you think?  Maybe an informal competition as to who makes the most unique, talented, craftsmanship like, silly, serious, whatever!  Give it some thought.
     The next order of business had to do with the generous donation of time and resources made by Steve Mongrain to provide the club with business cards.  We can use these to invite other woodworkers to the group, I doubt that many in the Las Vegas valley really know who we are but we are growing.  Hopefully everyone of you picked up a few to put in your wallet and keep with you to pass out.  I forgot!, I'm sure Jamie has them so if you're like me you'll have to get them from her.  If any of us in the group need business cards, flyers, announcements, etc. here is a LINK to Steve's business website.  If you want to contact him directly his email is steve@vvbf.com
     Next up was the demonstration on making half blind dovetails and I appreciate the interest everyone showed as I did this for you.  It's one of those woodworking process that either goes well or else can go terribly wrong!  Come to think of it, most every step involved with woodworking could end in disaster couldn't it?  Who hasn't cut a board on the wrong side of the line or split it as you drive in a screw, that's what makes it so intriguing, the challenge of it all.  Probably isn't hard to tell that I love the handwork aspect of woodworking, quiet and relatively dust free.  My nature is to pit myself against an obstacle and then figure out how to overcome it.  The method I used is not the only way to go about it, just what works for me.  Thanks to Allison for her fine photography, here is a photo essay of the process:

Using a dovetail marker (1:6) and marking knife to lay out the tails

Making the initial cuts for the tails

Paring the shoulder to the scribed line

Transferring the tails to the drawer front (pin board) 

Initial cuts with the backsaw for the socket the tail will fit into

Using a piece of a hand scraper to sever the fibers inside of the socket

Chopping out the sockets, leaving the pins

Removing socket waste

Much trial and error to get the fit -- patience required

Ahhhh -- Success!

Close up of completed joint, no glue yet